8275,00 €
Hydraulic roof truss press for pressing nail plates – MiTek MiTopW, GNT100 and other manufacturers' nail plates into C24 timber.
The press is fully equipped with the entire portal hoist, control unit, winch, hydraulic pump and other accessories. Only a 220V-10A or 16A connection is required.
We will cut the press portal telpher to your needs up to 12m wide. The working area of the press is 400x300mm
The set includes:
– C-press with all hydraulic and electrical connections, cylinder and control buttons.
– Portal hoist with lifting capacity – 800kg
– Automatic box (integrated on the cable car guide)
– Hydraulic pump (integrated on the hoist guide)
– Other accessories for use
The press will press the largest nail plate within 10 seconds with maximum force.
A press with a high-power pump will press the board in 5 seconds.
The press has a raised opening to allow pressing of elements up to 170mm high.
Maximum press force – 30 tons
Production time – 30 days
Presi pielāgosim Jūsu vajadzībām.
The use of a roof truss press allows for the efficient and high-quality production of roof structural elements, which are essential in the modern construction industry.
A roof truss press is a specialized machine used in the production of roof structures. It is designed to connect and fasten roof truss elements.
Place the press over the joint.
Slowly and steadily press the press lever to press the plate into the wood.
Make sure the plate is fully pressed.
If you are unsure about using a press, consult an expert or take training. Remember, that accurate and safe use is important to ensure a high-quality and safe roof construction.
